Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012E 350 V8-5.4LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER MOTORSERVICE AND REPAIR
2012 Ford E 350 V8-5.4L
Wiper Motor: Service and Repair
2012 Ford E 350 V8-5.4LSECTION Service and Repair
Wiper Motor
Removal and Installation
1. Remove the windshield wiper pivot arms. For additional information, refer to Wiper Pivot Arm Wiper Pivot Arm.
2. Remove the cowl top vent panels.
3. Disconnect the windshield wiper mounting arm and pivot shaft.
1. Remove the access cover from the dash panel.
2. Remove the retaining clip.
3. Disconnect the windshield wiper mounting arm and pivot shaft from the windshield wiper motor.
4. Remove the windshield wiper motor.
1. Disconnect the electrical connector.
2. Remove the 3 bolts.
- To install, tighten to 4 Nm (35 lb-in).
3. Remove the windshield wiper motor.
5. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.