Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012E 350 V8-5.4LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSEXHAUST SYSTEMEXHAUST MANIFOLD
2012 Ford E 350 V8-5.4L
Exhaust Manifold
2012 Ford E 350 V8-5.4LSECTION Exhaust Manifold
RH
Install 8 new exhaust manifold-to-cylinder head studs.
Tighten to 12 Nm (106 lb-in).
Using new exhaust manifold gaskets, position the exhaust manifold and install the 8 new nuts in the sequence shown.
Tighten to 25 Nm (18 lb-ft).
LH
Install 8 new exhaust manifold-to-cylinder head studs.
Tighten to 12 Nm (106 lb-in).
Using new exhaust manifold gaskets, position the LH exhaust manifold and install the 8 new nuts in the sequence shown.
Tighten to 25 Nm (18 lb-ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.