Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012E 350 V8-5.4LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLRELAYS AND MODULES - BRAKES AND TRACTION CONTROLTRACTION CONTROL MODULESERVICE AND REPAIR
2012 Ford E 350 V8-5.4L
Traction Control Module: Service and Repair
2012 Ford E 350 V8-5.4LSECTION Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
1. If installing a new ABS module, connect the scan tool and upload the module configuration information from the ABS module.
2. Remove the Air Cleaner (ACL).
3. NOTE: Do not disconnect the hoses from the power steering reservoir.
Remove the 4 bolts and position the power steering fluid reservoir and bracket aside.
- To install, tighten the bolts to 28 Nm (21 lb-ft).
4. Remove the 3 bolts and position the degas bottle aside.
- To install, tighten the bolts to 10 Nm (89 lb-in).
5. Disconnect the ABS module electrical connector.
- Release the lock tab.
- Pull the connector from the module.
6. Remove the 4 screws and the ABS module.
- To install, tighten the screws to 5 Nm (44 lb-in).
7. To install, reverse the removal procedure.
1. If a new ABS module was installed, download the module configuration information from the scan tool.
2. For vehicles equipped with Roll Stability Control (RSC(R)), carry out the IVD Initialization sequence. Follow the scan tool directions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.