Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012E 250 V8-5.4LREPAIR AND DIAGNOSISMAINTENANCESERVICE INTERVALSROUTINE SERVICEEXCEPTIONS TO NORMAL SCHEDULENORMAL VEHICLE AXLE MAINTENANCE
2012 Ford E 250 V8-5.4L
Normal Vehicle Axle Maintenance
2012 Ford E 250 V8-5.4LSECTION Normal Vehicle Axle Maintenance
NORMAL VEHICLE AXLE MAINTENANCE
Rear axles and transfer case/power transfer unit (PTU) units containing synthetic lubricant and light duty trucks equipped with Ford-design axles are lubricated for life. These lubricants are not to be checked or changed unless service is required, or if a leak is suspected or the axle assembly has been submerged in water.
The axle and transfer case/PTU fluid should be changed anytime they have been submerged in water. Non-synthetic rear axle lubricants should be installed new every 4,800 km (3,000 mi) or 3 months, whichever occurs first, during extended trailer tow operation above 21�C (70�F) ambient and wide open throttle (WOT) for extended periods above 72 km/h (45 mph).
The 3,000 mile lube change interval may be waived if the axle was filled with 75W-140 synthetic gear lubricant. Add 4 ounces of additive friction modifier for complete refill of Traction-Lok� rear axles.
The axle lubricant should be changed anytime an axle has been submerged in water.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.