Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012E 150 V8-4.6LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - ACCESSORIES AND OPTIONAL EQUIPMENTPARKING ASSIST CONTROL MODULESERVICE AND REPAIR
2012 Ford E 150 V8-4.6L
Parking Assist Control Module: Service and Repair
2012 Ford E 150 V8-4.6LSECTION Service and Repair
Parking Aid Module (PAM)
NOTE: The Parking Aid Module (PAM) is located above the RH cowl side trim panel.
Removal and Installation
1. NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.
Upload the PAM (Parking Aid Module) configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programmable Module Installation (PMI)
2. If replacing the Parking Aid Module (PAM), proceed as follows:
- Disconnect the electrical connectors.
- Remove the PAM (Parking Aid Module) push-pins.
- Remove the PAM (Parking Aid Module).
3. If replacing the parking aid speaker only, proceed as follows:
- Disconnect the parking aid speaker electrical connector.
- Disengage the parking aid speaker clips.
- Remove the parking aid speaker.
4. To install, reverse the removal procedure.
- Download the PAM (Parking Aid Module) configuration information.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.