Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2001FOCUS ZX3 L4-2.0L DOHC VIN 3REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERTESTING AND INSPECTIONANTI-THEFT SECURITY ACCESS PROCEDURE
2001 Ford Focus ZX3 L4-2.0L DOHC VIN 3
Anti-Theft Security Access Procedure
2001 Ford Focus ZX3 L4-2.0L DOHC VIN 3SECTION Anti-Theft Security Access Procedure
NOTE:
^ The Anti-Theft Security Access Procedure is utilized to obtain Passive Anti-theft System (PATS) security access. PATS security access must be granted to erase ignition keys or enable/disable the spare key programming switch (PID SPARE KEY). The anti-theft security access procedure invokes a time delay prior to granting security access during which the scan tool must remain connected to the vehicle. Once security access has been granted, a security access command menu is displayed which offers various command options.
1. Select SECURITY ACCESS. This procedure will take approximately 10 minutes to carry out, during which time, the ignition switch must be in the RUN position and the scan tool must be connected to the vehicle.
2. After the security access procedure has been completed, a new menu will be displayed with command options. Select the functions as required before exiting out of this menu. (Do not select more functions than the procedure calls for).
^ The Anti-Theft Security Access Procedure is utilized to obtain Passive Anti-theft System (PATS) security access. PATS security access must be granted to erase ignition keys or enable/disable the spare key programming switch (PID SPARE KEY). The anti-theft security access procedure invokes a time delay prior to granting security access during which the scan tool must remain connected to the vehicle. Once security access has been granted, a security access command menu is displayed which offers various command options.
1. Select SECURITY ACCESS. This procedure will take approximately 10 minutes to carry out, during which time, the ignition switch must be in the RUN position and the scan tool must be connected to the vehicle.
2. After the security access procedure has been completed, a new menu will be displayed with command options. Select the functions as required before exiting out of this menu. (Do not select more functions than the procedure calls for).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.