Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999TAURUS V6-3.0L VIN 2 FLEX FUELREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - INSTRUMENT PANELLAMP OUT MODULESERVICE AND REPAIR
1999 Ford Taurus V6-3.0L VIN 2 Flex Fuel
Lamp Out Module: Service and Repair
1999 Ford Taurus V6-3.0L VIN 2 Flex FuelSECTION Service and Repair
REMOVAL
1. Open luggage compartment door.
2. Pull RH luggage compartment trim panel out towards center of vehicle to reveal lamp out warning module in RH rear inner fender.
3. Remove two screws retaining lamp out warning module to body.
4. Disconnect harness connector from lamp out warning module and remove warning module from vehicle.
INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten retaining screws to 1.6-2.2 N.m (15-19 Lb-In).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.