Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999TAURUS V6-3.0L VIN 2 FLEX FUELREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTGENERAL MODULESERVICE AND REPAIR
1999 Ford Taurus V6-3.0L VIN 2 Flex Fuel
General Module: Service and Repair
1999 Ford Taurus V6-3.0L VIN 2 Flex FuelSECTION Service and Repair
REMOVAL
The Generic Electronic Module (GEM) is connected to the rear of the fuse junction panel.
1. Disconnect ground cable.
2. Remove two nuts retaining fuse junction panel to dash panel.
3. Pull upper ears of fuse junction panel down out of retaining bracket.
4. Disengage locking tangs and disconnect three harness connectors from bottom of GEM.
5. Turn fuse junction panel over and remove screw retaining GEM to fuse junction panel.
6. Disconnect and remove GEM from fuse junction panel.
INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten GEM to fuse junction panel screw to 1-2 N.m (9-17 Lb-In).
3. Tighten fuse junction panel retaining nuts to 4-6 N.m (36-53 Lb-In).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.