Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999TAURUS V6-3.0L DOHC VIN SREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSKNOCK SENSORSERVICE AND REPAIR
1999 Ford Taurus V6-3.0L DOHC VIN S
Knock Sensor: Service and Repair
1999 Ford Taurus V6-3.0L DOHC VIN SSECTION Service and Repair
Knock Sensor:
NOTE: The Knock Sensor (KS) is located on the RH side of the cylinder block.
REMOVAL
1. Disconnect battery ground cable.
2. Raise vehicle on hoist.
3. Disconnect engine control sensor wiring from knock sensor.
4. Remove heat shield boot from knock sensor.
5. Remove knock sensor from cylinder block.
INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten knock sensor to 15-20 N.m (11-14 Lb-Ft).
3. Install heat shield boot over knock sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.