Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999TAURUS V6-3.0L DOHC VIN SREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULESERVICE AND REPAIRRESET PROCEDUREPOWERTRAIN CONTROL MODULE (PCM/KAM RESET)
1999 Ford Taurus V6-3.0L DOHC VIN S
Powertrain Control Module (PCM/KAM Reset)
1999 Ford Taurus V6-3.0L DOHC VIN SSECTION Powertrain Control Module (PCM/KAM Reset)
All OBDII scan tools support the Powertrain Control Module (PCM) reset.
The PCM Reset allows the scan tool to command the PCM to clear all emission-related diagnostic information. When resetting the PCM, a DTC P1000 will be stored in the PCM until all the OBD II system monitors or components have been tested to satisfy a drive cycle, without any other faults occurring.
The following events occur when a PCM reset is performed:
- Clears the number of Diagnostic Trouble Codes (DTCs).
- Clears the DTCs.
- Clears the freeze frame data.
- Clears diagnostic monitoring test results.
- Resets status of the OBD II system monitors.
- Sets DTC P1000.
NOTE: When using the New Generation Star (NGS) Scan Tool to perform a PCM reset, press the CLEAR button. This function is performed only after retrieval of continuous DTCs.
New Generation Star and Generic Scan Tool
Refer to the scan tool manufacturer's manual for specific instructions on how to perform PCM reset.
The PCM Reset allows the scan tool to command the PCM to clear all emission-related diagnostic information. When resetting the PCM, a DTC P1000 will be stored in the PCM until all the OBD II system monitors or components have been tested to satisfy a drive cycle, without any other faults occurring.
The following events occur when a PCM reset is performed:
- Clears the number of Diagnostic Trouble Codes (DTCs).
- Clears the DTCs.
- Clears the freeze frame data.
- Clears diagnostic monitoring test results.
- Resets status of the OBD II system monitors.
- Sets DTC P1000.
NOTE: When using the New Generation Star (NGS) Scan Tool to perform a PCM reset, press the CLEAR button. This function is performed only after retrieval of continuous DTCs.
New Generation Star and Generic Scan Tool
Refer to the scan tool manufacturer's manual for specific instructions on how to perform PCM reset.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.