Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999F 150 2WD PICKUP V6-4.2L VIN 2REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIR
1999 Ford F 150 2WD Pickup V6-4.2L VIN 2
Power Window Switch: Service and Repair
1999 Ford F 150 2WD Pickup V6-4.2L VIN 2SECTION Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the window regulator switch plate.
1 Pry up the window regulator switch plate.
2 Disconnect the electrical connectors.
3. Remove the window regulator control switch.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: When the battery ground cable is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
1. Disconnect the battery ground cable.
2. Remove the window regulator switch plate.
1 Pry up the window regulator switch plate.
2 Disconnect the electrical connectors.
3. Remove the window regulator control switch.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: When the battery ground cable is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.