Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999F 150 2WD PICKUP V6-4.2L VIN 2REPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SERVOSERVICE AND REPAIR
1999 Ford F 150 2WD Pickup V6-4.2L VIN 2
Cruise Control Servo: Service and Repair
1999 Ford F 150 2WD Pickup V6-4.2L VIN 2SECTION Service and Repair
REMOVAL
1. Remove the speed control actuator cable cap from the speed control servo.
1 Push in the locking arm on the speed control actuator cable cap.
2 Rotate the speed control actuator cable cap counterclockwise and remove the speed control actuator cable cap from the speed control servo.
2. Disconnect the speed control actuator cable from the speed control servo.
1 Depress the spring retainer.
2 Slide the core wire end out of the speed control servo pulley.
3. Disconnect the speed control servo electrical connector.
4. Remove the speed control servo and bracket.
1 Remove the bolts.
2 Remove the speed control servo and bracket.
NOTE: Do not remove the rubber grommets from the speed control servo bracket.
5. Remove the speed control servo bracket.
1 Remove the screws.
2 Remove the speed control servo bracket.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: The rubber grommets must be properly seated in the speed control servo bracket for proper noise and vibration isolation.
1. Remove the speed control actuator cable cap from the speed control servo.
1 Push in the locking arm on the speed control actuator cable cap.
2 Rotate the speed control actuator cable cap counterclockwise and remove the speed control actuator cable cap from the speed control servo.
2. Disconnect the speed control actuator cable from the speed control servo.
1 Depress the spring retainer.
2 Slide the core wire end out of the speed control servo pulley.
3. Disconnect the speed control servo electrical connector.
4. Remove the speed control servo and bracket.
1 Remove the bolts.
2 Remove the speed control servo and bracket.
NOTE: Do not remove the rubber grommets from the speed control servo bracket.
5. Remove the speed control servo bracket.
1 Remove the screws.
2 Remove the speed control servo bracket.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: The rubber grommets must be properly seated in the speed control servo bracket for proper noise and vibration isolation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.