Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999F 150 2WD PICKUP V6-4.2L VIN 2REPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SERVO CABLESERVICE AND REPAIR
1999 Ford F 150 2WD Pickup V6-4.2L VIN 2
Cruise Control Servo Cable: Service and Repair
1999 Ford F 150 2WD Pickup V6-4.2L VIN 2SECTION Service and Repair
REMOVAL
NOTE: 5.4L 2 Valve Triton V8 shown; others are similar.
1. Remove the accelerator control splash shield.
1 Remove the screws.
2 Remove the accelerator control splash shield.
2. Remove the speed control actuator cable from the throttle nail head.
1 Lift the speed control actuator cable upward.
2 Squeeze the speed control actuator cable tabs and remove from the throttle nail head.
3. Remove the speed control actuator cable cap from the speed control servo.
1 Push in the locking arm on the speed control actuator cable cap.
2 Rotate the speed control actuator cable cap counterclockwise and remove the speed control actuator cable cap from the speed control servo.
4. Remove the speed control actuator cable.
1 Depress the spring retainer.
2 Slide the core wire end out of the speed control servo pulley and remove the speed control actuator cable.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: 5.4L 2 Valve Triton V8 shown; others are similar.
1. Remove the accelerator control splash shield.
1 Remove the screws.
2 Remove the accelerator control splash shield.
2. Remove the speed control actuator cable from the throttle nail head.
1 Lift the speed control actuator cable upward.
2 Squeeze the speed control actuator cable tabs and remove from the throttle nail head.
3. Remove the speed control actuator cable cap from the speed control servo.
1 Push in the locking arm on the speed control actuator cable cap.
2 Rotate the speed control actuator cable cap counterclockwise and remove the speed control actuator cable cap from the speed control servo.
4. Remove the speed control actuator cable.
1 Depress the spring retainer.
2 Slide the core wire end out of the speed control servo pulley and remove the speed control actuator cable.
INSTALLATION
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.