Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999EXPEDITION 4WD V8-4.6L SOHC VIN 6REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL MODULE HVACSERVICE AND REPAIRELECTRONIC CLIMATE CONTROL MODULE
1999 Ford Expedition 4WD V8-4.6L SOHC VIN 6
Electronic Climate Control Module
1999 Ford Expedition 4WD V8-4.6L SOHC VIN 6SECTION Electronic Climate Control Module
WITH ELECTRONIC AUTOMATIC TEMPERATURE CONTROL
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the center instrument panel finish panel.
^ Carefully pry to release the four clips.
3. If equipped, disconnect the control switch connector.
4. Remove the climate control head.
1 Remove the screws.
2 Pull out the climate control head.
5. Disconnect the climate control head.
1 Disconnect the electrical connectors.
2 Disconnect the vacuum line connector.
INSTALLATION
1. To install, reverse the removal procedure.
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the center instrument panel finish panel.
^ Carefully pry to release the four clips.
3. If equipped, disconnect the control switch connector.
4. Remove the climate control head.
1 Remove the screws.
2 Pull out the climate control head.
5. Disconnect the climate control head.
1 Disconnect the electrical connectors.
2 Disconnect the vacuum line connector.
INSTALLATION
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.