Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999ESCORT ZX2 L4-2.0L DOHC VIN 3REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRCONTROL ASSEMBLY, HVACFUNCTION CONTROL SWITCH
1999 Ford Escort ZX2 L4-2.0L DOHC VIN 3
Function Control Switch
1999 Ford Escort ZX2 L4-2.0L DOHC VIN 3SECTION Function Control Switch
REMOVAL
1. Remove the control assembly.
2. Remove the function selector knob.
3. Disconnect the function selector switch electrical connector.
4. Remove the function selector switch.
INSTALLATION
1. Follow the removal procedure in reverse order.
1. Remove the control assembly.
2. Remove the function selector knob.
3. Disconnect the function selector switch electrical connector.
4. Remove the function selector switch.
INSTALLATION
1. Follow the removal procedure in reverse order.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.