Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999ESCORT ZX2 L4-2.0L DOHC VIN 3REPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIR
1999 Ford Escort ZX2 L4-2.0L DOHC VIN 3
Cruise Control Switch: Service and Repair
1999 Ford Escort ZX2 L4-2.0L DOHC VIN 3SECTION Service and Repair
Special Tool(s)
REMOVAL
1. Remove the driver side air bag module.
2. Remove the steering wheel bolt.
3. Use (A) Steering Wheel Puller to remove the (B) steering wheel.
4. Tape the (A) air bag sliding contact to the (B) steering column housing to prevent misalignment.
5. Remove the (A) screws from the back of the steering wheel and remove the (B) steering wheel trim.
6. Remove the (A) screws and the (B) speed control actuator switch.
INSTALLATION
1. Install the (A) speed control actuator switch and the (B) screws.
2. Position the (A) steering wheel trim and install the (B) screws.
3. Remove the tape holding the air bag sliding contact in position.
4. Install the steering wheel.
NOTE:
- Ensure the steering wheel is correctly aligned prior to installing it on the steering column.
- Route the wire connectors through the steering wheel trim cover prior to installing the steering wheel.
5. Install the steering wheel bolt. Tighten bolt to 46-63 Nm (34-46 lb-ft).
6. Install the driver side air bag module.
WARNING: When carrying a live air bag, make sure the bag and trim cover are pointed away from your body. In the unlikely event of an accidental deployment, the bag will then deploy with minimal chance of injury.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.