Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999ECONOLINE E350 1 TON V10-6.8L VIN SREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCOOLANT TEMPERATURE SENSOR/SWITCH (FOR COMPUTER)SERVICE AND REPAIR
1999 Ford Econoline E350 1 Ton V10-6.8L VIN S
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
1999 Ford Econoline E350 1 Ton V10-6.8L VIN SSECTION Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Partially drain the cooling system.
3. Remove the Engine Coolant Temperature (ECT) sensor.
1 Disconnect the electrical connector.
2 Remove the ECT sensor.
INSTALLATION
1. To install, reverse the removal procedure.
1. Disconnect the battery ground cable.
2. Partially drain the cooling system.
3. Remove the Engine Coolant Temperature (ECT) sensor.
1 Disconnect the electrical connector.
2 Remove the ECT sensor.
INSTALLATION
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.