Air Flow Meter/Sensor: Service and Repair

1999 Ford Econoline E350 1 Ton V10-6.8L VIN SSECTION Service and Repair
REMOVAL
1. Disconnect the battery ground cable.

NOTE: The sensing elements located inside the Mass Air Flow (MAF) sensor can be damaged by touching.

2. Remove the air cleaner assembly.







3. Separate the two halves of the air cleaner housing.







4. Disconnect the wiring connector from housing.







5. Remove the bolts, mounting plate and the MAF sensor.

INSTALLATION
1. To install, reverse the removal procedure
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.