Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999ECONOLINE E150 1/2 TON V6-4.2L VIN 2REPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER CONTROL MODULESERVICE AND REPAIR
1999 Ford Econoline E150 1/2 Ton V6-4.2L VIN 2
Wiper Control Module: Service and Repair
1999 Ford Econoline E150 1/2 Ton V6-4.2L VIN 2SECTION Service and Repair
REMOVAL
1. Remove the engine cover.
2. Remove the wiper module.
1. Disconnect the electrical connector.
2. Push the detent tabs on the wiper control module through the holes in the mounting bracket and slide the module off the bracket.
3. Remove the wiper control module.
INSTALLATION
1. To install, reverse the removal procedure.
1. Remove the engine cover.
2. Remove the wiper module.
1. Disconnect the electrical connector.
2. Push the detent tabs on the wiper control module through the holes in the mounting bracket and slide the module off the bracket.
3. Remove the wiper control module.
INSTALLATION
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.