Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999ECONOLINE E150 1/2 TON V6-4.2L VIN 2REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVEHICLE SPEED SENSORSERVICE AND REPAIR
1999 Ford Econoline E150 1/2 Ton V6-4.2L VIN 2
Vehicle Speed Sensor: Service and Repair
1999 Ford Econoline E150 1/2 Ton V6-4.2L VIN 2SECTION Service and Repair
Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Remove the vehicle speed sensor (VSS).
1 Disconnect the electrical connector.
2 Remove the bolt.
3 Remove the VSS.
4. Remove the vehicle speed sensor (VSS) drive gear.
1 Remove the retaining clip.
2 Remove the driven gear.
Installation
1. Install vehicle speed sensor (VSS) drive gear.
1 Install the driven gear.
2 Install the retaining clip.
2. Install the VSS.
1 Install the VSS.
2 Install the bolt.
3 Connect the electrical connector.
3. Lower the vehicle.
4. Connect the battery ground cable.
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Remove the vehicle speed sensor (VSS).
1 Disconnect the electrical connector.
2 Remove the bolt.
3 Remove the VSS.
4. Remove the vehicle speed sensor (VSS) drive gear.
1 Remove the retaining clip.
2 Remove the driven gear.
Installation
1. Install vehicle speed sensor (VSS) drive gear.
1 Install the driven gear.
2 Install the retaining clip.
2. Install the VSS.
1 Install the VSS.
2 Install the bolt.
3 Connect the electrical connector.
3. Lower the vehicle.
4. Connect the battery ground cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.