Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999ECONOLINE E150 1/2 TON V6-4.2L VIN 2REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRREAR CONTROL ASSEMBLY
1999 Ford Econoline E150 1/2 Ton V6-4.2L VIN 2
Rear Control Assembly
1999 Ford Econoline E150 1/2 Ton V6-4.2L VIN 2SECTION Rear Control Assembly
REMOVAL
1. Remove the rear climate control panel.
^ Use a screwdriver to carefully pry the rear climate control panel out of the headliner.
2. Disconnect the electrical hard-shell connectors.
^ Disconnect the heater blower motor switch connector.
^ Disconnect the lamp connector.
3. Remove the knob.
4. Remove the heater blower motor switch.
1 Remove the screw.
2 Remove the heater blower motor switch.
INSTALLATION
1. To install, reverse the removal procedure.
1. Remove the rear climate control panel.
^ Use a screwdriver to carefully pry the rear climate control panel out of the headliner.
2. Disconnect the electrical hard-shell connectors.
^ Disconnect the heater blower motor switch connector.
^ Disconnect the lamp connector.
3. Remove the knob.
4. Remove the heater blower motor switch.
1 Remove the screw.
2 Remove the heater blower motor switch.
INSTALLATION
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.