Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999ECONOLINE E150 1/2 TON V6-4.2L VIN 2REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYSERVICE AND REPAIRPROGRAMMING WITH ICONS
1999 Ford Econoline E150 1/2 Ton V6-4.2L VIN 2
Programming With Icons
1999 Ford Econoline E150 1/2 Ton V6-4.2L VIN 2SECTION Programming With Icons
NOTE:
^ All keyless entry remote transmitters must be programmed at the same time.
^ To program (or reprogram) the keyless entry remote transmitters into the Remote Keyless Entry (RKE) module, perform the following steps:
1. Turn the ignition switch from OFF to RUN eight times within ten seconds, ending in RUN. If the RKE module has successfully entered program mode, it will lock and then unlock all doors.
2. Within 20 seconds, press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed. Repeat this step for each transmitter.
3. If the door locks do not respond for any keyless entry remote transmitter, wait several seconds and press the button again. If the door locks still fail to respond, refer to Inspection and Verification. Inspection and Verification (Start Testing Here)
4. Turn the ignition switch to the OFF position, or wait up to 20 seconds after step 2, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the RKE module will lock and unlock all doors one last time to confirm.
^ All keyless entry remote transmitters must be programmed at the same time.
^ To program (or reprogram) the keyless entry remote transmitters into the Remote Keyless Entry (RKE) module, perform the following steps:
1. Turn the ignition switch from OFF to RUN eight times within ten seconds, ending in RUN. If the RKE module has successfully entered program mode, it will lock and then unlock all doors.
2. Within 20 seconds, press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed. Repeat this step for each transmitter.
3. If the door locks do not respond for any keyless entry remote transmitter, wait several seconds and press the button again. If the door locks still fail to respond, refer to Inspection and Verification. Inspection and Verification (Start Testing Here)
4. Turn the ignition switch to the OFF position, or wait up to 20 seconds after step 2, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the RKE module will lock and unlock all doors one last time to confirm.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.