Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1994TAURUS V6-182 3.0L DOHC SHOREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - INSTRUMENT PANELAUDIBLE WARNING DEVICE CONTROL MODULESERVICE AND REPAIR
1994 Ford Taurus V6-182 3.0L DOHC SHO
Audible Warning Device Control Module: Service and Repair
1994 Ford Taurus V6-182 3.0L DOHC SHOSECTION Service and Repair
NOTE: The safety belt warning chime is mounted on a bracket to the RH side of the steering column, on the instrument panel reinforcement.
REMOVAL
1. Disconnect battery ground cable.
2. Depress tab on safety belt warning chime and slide module off bracket.
3. Disconnect electrical connector to safety belt warning chime.
4. Remove safety belt warning chime.
INSTALLATION
1. To install, reverse Removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.