Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1994TAURUS V6-182 3.0L DOHC SHOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTHROTTLE POSITION SENSORSERVICE AND REPAIR
1994 Ford Taurus V6-182 3.0L DOHC SHO
Throttle Position Sensor: Service and Repair
1994 Ford Taurus V6-182 3.0L DOHC SHOSECTION Service and Repair
Throttle Position Sensor:
REMOVAL
1. Disconnect Throttle Position (TP) sensor from fuel charging wiring (9D930).
2. Remove two TP sensor retaining screws.
3. Remove TP sensor.
INSTALLATION
CAUTION: Slide rotary tangs into position over throttle shaft blade, then rotate TP sensor clockwise to installed position only. Failure to install the TP sensor in this manner may result in excessive idle speeds.
1. Install TP sensor. Ensure that rotary tangs on sensor are in proper alignment and that the red seal is inside the connector housing.
NOTE: This TP sensor is not adjustable.
2. Secure TP sensor to throttle body assembly with two retaining screws. Tighten to 1.5 Nm (14 in lb).
3. Connect fuel charging wiring connector to TP sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.