Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
X85 - Check Inertia Fuel Shutoff Switch
1994 Ford Taurus V6-182 3.0L DOHC SHOSECTION X85 - Check Inertia Fuel Shutoff Switch
- Key "OFF".
- Locate and disconnect Inertia Fuel Shutoff (IFS) switch (verify that switch is reset).
- Measure resistance between the "C" and "NC" pins of the IFS switch.
- Is resistance less than 5.0 ohms?
Yes -- Reconnect IFS switch. Refer to Fuel Delivery and Air Induction for open in power-to-pump circuit, poor fuel pump ground, open in fuel pump, etc.
No -- Replace or reset IFS switch. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.