X73 - Check Continuity of Fuel Pump Circuit

1994 Ford Taurus V6-182 3.0L DOHC SHOSECTION X73 - Check Continuity of Fuel Pump Circuit


- Key "OFF".

- Constant Control Relay Module (CCRM) disconnected.

- Disconnect Powertrain Control Module (PCM). Inspect for damaged or pushed out pins, corrosion, loose wires. etc. Service as necessary.

- Install breakout box, leave PCM disconnected.

- Measure resistance between test pin 22 at the breakout box and Pin 18 at the CCRM vehicle harness connector.

- Measure resistance between test pin 41 at the breakout box and Pin 18 at the CCRM vehicle harness connector.

- Is resistance less than 5.0 ohms?

Yes -- Go to X74. X74 - Check Fuel Pump Circuit For Short to Power

No -- Service open in fuel pump circuit. Remove breakout box. Reconnect all components. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.