Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1994TAURUS V6-182 3.0L DOHC SHOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONPINPOINT TESTSH - FUEL CONTROLH90 - CHECK CONTINUOUS MONITOR DIAGNOSTIC TEST MODE
1994 Ford Taurus V6-182 3.0L DOHC SHO
H90 - Check Continuous Monitor Diagnostic Test Mode
1994 Ford Taurus V6-182 3.0L DOHC SHOSECTION H90 - Check Continuous Monitor Diagnostic Test Mode
- Key "OFF".
- Verify engine at operating temperature.
- Start engine and run at 2000 rpm for two minutes.
- With engine rpm at idle enter Engine Running Continuous Monitor (DTM). Continuous Monitor Diagnostic Test Mode (Wiggle Test)
- Observe Analog Volt/Ohm Meter (VOM) or STAR LED for indication of fault.
- Wiggle, shake or bend a small section of the Electronic Engine Controls (EEC) harness while working your way from the Heated Oxygen Sensor (HO2S) to the Powertrain Control Module (PCM).
- Wiggle, shake or bend a small section of the EEC harness while working your way from the HO2S GND to the PCM.
- Is a fault indicated?
Yes -- Isolate fault and service as necessary. Remove breakout box. Clear continuous memory. Clearing Diagnostic Trouble Codes
Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)
No -- Remain in Engine Running Continuous Monitor Test Mode. Go to H91. H91 - Continuous Monitor DTM Test Drive Check
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.