Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1995SUMMIT WAGON AWD L4-1795CC 1.8L SOHCREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - RESTRAINTS AND SAFETY SYSTEMSAIR BAG CONTROL MODULESERVICE AND REPAIR
1995 Eagle Summit Wagon AWD L4-1795cc 1.8L SOHC
Air Bag Control Module: Service and Repair
1995 Eagle Summit Wagon AWD L4-1795cc 1.8L SOHCSECTION Service and Repair
The ACM/Air Bag System Diagnostic Module (ASDM) and SRS diagnosis unit (SDU) contain one of the impact sensors which enables system to activate air bag. The ACM/Air Bag Electronic Control Module (AECM) and SRS air bag control unit (SRS-ECU) contain the impact sensors which enables system to activate air bag.
To avoid accidental deployment, never connect ACM/ASDM, ACM/AECM, SDU or SRS-ECU electrically to system unless it is bolted to vehicle.
1. Disarm air bag as described under Air Bag System Disarming & Arming at Air Bag Systems/ Service and Repair.
2. Remove side cover, manual transaxle shift lever knob, and floor console switch panel.
3. Remove armrest assembly, bolts and floor console.
4. Remove SRS-ECU harness connectors, then SRS--ECU and bracket.
5. Reverse procedure to install.
To avoid accidental deployment, never connect ACM/ASDM, ACM/AECM, SDU or SRS-ECU electrically to system unless it is bolted to vehicle.
1. Disarm air bag as described under Air Bag System Disarming & Arming at Air Bag Systems/ Service and Repair.
2. Remove side cover, manual transaxle shift lever knob, and floor console switch panel.
3. Remove armrest assembly, bolts and floor console.
4. Remove SRS-ECU harness connectors, then SRS--ECU and bracket.
5. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.