Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1995SUMMIT WAGON AWD L4-1795CC 1.8L SOHCREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRFRONT ALIGNMENTPRELIMINARY INSPECTION
1995 Eagle Summit Wagon AWD L4-1795cc 1.8L SOHC
Preliminary Inspection
1995 Eagle Summit Wagon AWD L4-1795cc 1.8L SOHCSECTION Preliminary Inspection
PRELIMINARY INSPECTION
1. Road test vehicle, noting any abnormal steering or handling characteristics.
2. Ensure tires are of proper type, are correctly inflated and that tires on each axle are same size.
3. Ensure tires conform with size recommendations for vehicle.
4. Inspect ball joints, suspension arms, bushings and tie rods; repair or replace any component that is damaged or excessively worn.
5. Ensure wheel runout is not excessive, and that wheel bearings are properly adjusted.
6. Jounce vehicle several times to settle suspension.
7. Place vehicle on suitable alignment rack following manufacturer's instructions.
8. Check and correct alignment angles in following sequence: rear toe and camber, caster, front camber and front toe.
9. Correct any angle that is not within specifications. If no adjustment is possible, check for damaged or worn suspension components and/or damaged or distorted chassis members and correct as needed.
1. Road test vehicle, noting any abnormal steering or handling characteristics.
2. Ensure tires are of proper type, are correctly inflated and that tires on each axle are same size.
3. Ensure tires conform with size recommendations for vehicle.
4. Inspect ball joints, suspension arms, bushings and tie rods; repair or replace any component that is damaged or excessively worn.
5. Ensure wheel runout is not excessive, and that wheel bearings are properly adjusted.
6. Jounce vehicle several times to settle suspension.
7. Place vehicle on suitable alignment rack following manufacturer's instructions.
8. Check and correct alignment angles in following sequence: rear toe and camber, caster, front camber and front toe.
9. Correct any angle that is not within specifications. If no adjustment is possible, check for damaged or worn suspension components and/or damaged or distorted chassis members and correct as needed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.