Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1994SUMMIT WAGON AWD L4-1795CC 1.8L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTRANSMISSION CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESTHROTTLE POSITION SENSOR
1994 Eagle Summit Wagon AWD L4-1795cc 1.8L SOHC
Throttle Position Sensor
1994 Eagle Summit Wagon AWD L4-1795cc 1.8L SOHCSECTION Throttle Position Sensor
INSPECTION CONDITION CRITERION VALUE
Accelerator is fully closed 0.5 - 0.6 volts
Slowly depress the accelerator pedal Variation of opening degree
Accelerator is fully opened 4.5 - 5.0 volts
POSSIBLE CAUSE (OR REMEDY) FOR THE ABNORMALITY
- If voltage is high at the full throttle opening or closing, Throttle Position Sensor (TPS) is adjusted improperly.
- If no variation is observed, TPS or circuit harness is defective.
- If it does not vary smoothly, TPS or accelerator cable is defective.
Accelerator is fully closed 0.5 - 0.6 volts
Slowly depress the accelerator pedal Variation of opening degree
Accelerator is fully opened 4.5 - 5.0 volts
POSSIBLE CAUSE (OR REMEDY) FOR THE ABNORMALITY
- If voltage is high at the full throttle opening or closing, Throttle Position Sensor (TPS) is adjusted improperly.
- If no variation is observed, TPS or circuit harness is defective.
- If it does not vary smoothly, TPS or accelerator cable is defective.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.