Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1994SUMMIT WAGON AWD L4-1795CC 1.8L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSAIR FLOW METER/SENSORSERVICE AND REPAIR
1994 Eagle Summit Wagon AWD L4-1795cc 1.8L SOHC
Air Flow Meter/Sensor: Service and Repair
1994 Eagle Summit Wagon AWD L4-1795cc 1.8L SOHCSECTION Service and Repair
Volume Air Flow Sensor Location:
REMOVAL
1. Ensure that the ignition switch is in the OFF position and disconnect the battery.
2. Remove the air flow sensor connector on the air filter housing lid.
3. Release the clips holding the lid to the air filter housing.
4. Remove the lid with the air flow sensor attached.
5. Locate and remove the attachment bolts (to the lid) and remove the air flow sensor.
INSTALLATION
1. Attach the air flow sensor to the air filter housing lid.
2. Install the lid on the air filter housing.
3. Connect the air flow sensor connector.
4. Connect the battery.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.