Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1992SUMMIT VISTA AWD L4-2350CC 2.4L SOHCREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULETESTING AND INSPECTIONIDLE LEARN PROCEDURE, BATTERY/POWER DISCONNECT
1992 Eagle Summit Vista AWD L4-2350cc 2.4L SOHC
Idle Learn Procedure, Battery/Power Disconnect
1992 Eagle Summit Vista AWD L4-2350cc 2.4L SOHCSECTION Idle Learn Procedure, Battery/Power Disconnect
1. Prior to connecting or disconnecting the negative battery cable, turn ignition switch and light switch off.
CAUTION: Failure to do so may result in damage to semiconductor parts.
2. After reconnecting negative battery terminal start and warm engine. Allow engine to idle for approximately 5 minutes under the following conditions.
Engine coolant temperature 185 - 203°F (85 - 95°C)
Lights, electric fans, accessories OFF
Transaxle neutral
Steering wheel in center position
CAUTION: Failure to do so may result in damage to semiconductor parts.
2. After reconnecting negative battery terminal start and warm engine. Allow engine to idle for approximately 5 minutes under the following conditions.
Engine coolant temperature 185 - 203°F (85 - 95°C)
Lights, electric fans, accessories OFF
Transaxle neutral
Steering wheel in center position
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.