Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1992SUMMIT VISTA AWD L4-2350CC 2.4L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMDISTRIBUTORSERVICE AND REPAIR
1992 Eagle Summit Vista AWD L4-2350cc 2.4L SOHC
Distributor: Service and Repair
1992 Eagle Summit Vista AWD L4-2350cc 2.4L SOHCSECTION Service and Repair
Component Overview:
REMOVAL:
1. Disconnect battery ground cable.
2. Remove retaining clips, distributor cap and seal ring.
3. Place an alignment mark on distributor body and engine block, indicating position of distributor body in block or cylinder head. Place No. 1 cylinder to TDC of compression stroke. Place another mark on distributor body indicating position of rotor. Do not use a sharp tool to place alignment marks on distributor body and engine block or cylinder head.
4. Disconnect wiring harness from distributor lead wire.
5. Remove distributor mounting nut, then the distributor assembly from engine.
INSTALLATION:
1. Turn the crankshaft so that the No.1 cylinder is at top dead center.
Distributor Housing To Drive Gear Alignment Marks:
2. Align the distributor housing and gear mating marks.
Distributor Housing To Mounting Stud Alignment Mark:
3. Install the distributor to the engine while aligning the fine cut (groove) on the distributor's installation flange with the center of the distributor installation stud.
4. Check ignition timing, refer to ADJUSTMENT PROCEDURES section.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.