Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1992SUMMIT VISTA AWD L4-2350CC 2.4L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTHROTTLE POSITION SENSORSERVICE AND REPAIR
1992 Eagle Summit Vista AWD L4-2350cc 2.4L SOHC
Throttle Position Sensor: Service and Repair
1992 Eagle Summit Vista AWD L4-2350cc 2.4L SOHCSECTION Service and Repair
Throttle Position Sensor Location:
REMOVAL
1. Disconnect the harness connector.
2. Remove the two mounting screws.
3. Remove the sensor.
INSTALLATION
1. Install the sensor.
2. Install the two mounting screws.
3. Reconnect the harness connector.
4. Refer to ADJUSTMENT PROCEDURES for adjustment to obtain the proper alignment setting.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.