Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE2007MAGNUM SRT-8 V8-6.1L VIN 3REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWER AND GROUND DISTRIBUTIONPOWER DISTRIBUTION MODULESERVICE AND REPAIRMODULE-FRONT CONTROLREMOVAL
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3
Removal
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3SECTION Removal
REMOVAL
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected.
1. Disconnect and isolate the battery negative cable.
2. Remove mounting fasteners.
3. Disconnect electrical connectors and remove Front Control Module (FCM).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.