Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE2007MAGNUM SRT-8 V8-6.1L VIN 3REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - HVACCONTROL MODULE HVACSERVICE AND REPAIRBLOWER MOTOR POWER MODULE - INSTALLATION
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3
Blower Motor Power Module - Installation
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3SECTION Blower Motor Power Module - Installation
INSTALLATION
NOTE: LHD model shown. RHD model similar.
1. Position the blower motor power module (2) into the HVAC housing (4).
2. Install the two screws (3) that secure the blower motor power module to the HVAC housing. Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the two wire harness connectors (1) to the blower motor power module.
4. Install the glove box into the instrument panel.
5. Reconnect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.