Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE2007MAGNUM SRT-8 V8-6.1L VIN 3REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMESEAT TEMPERATURE CONTROL MODULESERVICE AND REPAIRREAR SEATSINSTALLATION
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3
Installation
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3SECTION Installation
INSTALLATION
1. Align the tabs (1) of the switch/module (2) to the bezel and gently push together until the tabs are securely in place.
2. Connect the switch/module electrical connectors (2) and (4).
3. Gently push the heated seat switch/module bezel (1) into the mounting hole in the center console until it is securely in place.
4. Connect the battery negative cable.
5. Verify heated seat system operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.