Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE2007MAGNUM SRT-8 V8-6.1L VIN 3REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMESEAT TEMPERATURE CONTROL MODULESERVICE AND REPAIRFRONT SEATSINSTALLATION
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3
Installation
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3SECTION Installation
INSTALLATION
1. Install the heated seat module (3) in the vehicle.
2. Position the retaining clips (2) with the retaining holes (1) in the floor cross member. Firmly apply even pressure to the module (3) until all four retaining clips (2) snap into place.
3. Connect the wire harness connector (3) to the heated seat module (1).
4. Reposition the front carpet assembly to the original position.
5. Install the right, front seat.
6. Connect the battery negative cable.
7. Check for proper heated seat system operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.