Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE2007MAGNUM SRT-8 V8-6.1L VIN 3REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULEDIAGRAMSDIAGRAM INFORMATION AND INSTRUCTIONSSECTION IDENTIFICATION AND INFORMATION
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3
Section Identification and Information
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3SECTION Section Identification and Information
DESCRIPTION - SECTION IDENTIFICATION AND INFORMATION
The wiring diagrams are grouped into individual sections. If a component is most likely found in a particular group, it will be shown complete (all wires, connectors, and pins) within that group. For example, the Auto Shutdown Relay is most likely to be found in Powertrain Management, so it is shown there complete. It can, however, be shown partially in another group if it contains some associated wiring.
Splice diagrams show the entire splice and provide references to other sections the splices serves. Splice Information contains splice diagrams that are not shown in their entirety somewhere else in the wiring diagrams.
Connector Pin-Outs shows each connector and the circuits involved with that connector. The connectors are identified using the name/number on the diagram pages.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.