Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE2007MAGNUM SRT-8 V8-6.1L VIN 3REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOXYGEN SENSORSERVICE AND REPAIRINSTALLATION
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3
Installation
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3SECTION Installation
6.1L
NOTE: When replacing an O2 Sensor, the PCM's RAM memory must be cleared. This can be done by either by disconnecting the PCM's C-1 connector, or by momentarily disconnecting the negative battery cable. The PCM learns the characteristics of each O2 heater element, and these old values should be cleared when installing a new O2 sensor. Driveability problems may be experienced if this step is not performed.
CAUTION: Never apply any type of grease to the oxygen sensor electrical connector, or attempt any soldering of the sensor wiring harness.
Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal. DO NOT add any additional anti-seize compound to threads of a new oxygen sensor.
1. Install O2S sensor. Tighten to 30 Nm (22 ft. lbs.) torque.
2. Connect O2S sensor wire connector.
3. Lower vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.