Installation

2007 Dodge Magnum SRT-8 V8-6.1L VIN 3SECTION Installation





INSTALLATION





1. Position the A/C-heater control (2) into the instrument panel center bezel (3).

2. Install the four screws (1) that secure the A/C-heater control to the instrument panel center bezel. Tighten the screws to 2 Nm (17 in. lbs.).





3. Connect the wire harness connector(s) (3) to the A/C-heater control (4) and install the instrument panel center bezel (1) to the instrument panel (2).

NOTE: The A/C-heater control will automatically perform the Actuator Calibration function when the ignition is initially turned on when installing a new control or when reinstalling the original control. However, the Actuator Calibration function must be manually initiated using a scan tool if the A/C-heater control has been previously installed in another vehicle.

4. Reconnect the negative battery cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.