Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE2007MAGNUM SRT-8 V8-6.1L VIN 3REPAIR AND DIAGNOSISCRUISE CONTROLRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULESERVICE AND REPAIRREMOVAL
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3
Removal
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3SECTION Removal
REMOVAL
1. Disconnect negative battery cable.
2. Remove air dam panels.
3. Air dam panels removed.
4. Remove 3 mounting bolts.
5. Remove module/sensor assembly.
6. Remove wiring harness clips from bracket and radiator side shield.
7. Disconnect electrical connector.
8. Remove assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.