Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE2007MAGNUM SRT-8 V8-6.1L VIN 3REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSELECTRONIC BRAKE CONTROL MODULESERVICE AND REPAIRMODULE-ANTILOCK BRAKE - MK25INSTALLATION
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3
Installation
2007 Dodge Magnum SRT-8 V8-6.1L VIN 3SECTION Installation
INSTALLATION
1. Align ABM solenoids and pump/motor wiring connector (4) with HCU valves (2) and connector passage. Slide ABM (1) onto HCU (3).
2. Install three screws (2) attaching ABM (1) to HCU. Tighten screws to 2 Nm (17 in. lbs.) torque.
3. Position assembly (5) above mounting grommets (8) and press mounting bracket into place.
4. Clip brake tube (3) to routing clip (4) below Fuse And Relay Center.
5. Clip brake tubes (1, 2 and 10) to two routing clips (6) along upper radiator support.
6. Connect 47-way wiring connector (5) at ABM (6).
7. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
8. Perform Diagnostic Verification Test and clear any faults.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.