Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE2006MAGNUM SRT-8 V8-6.1L VIN 3REPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNSTEERING COLUMN CONTROL MODULESERVICE AND REPAIRASSEMBLY
2006 Dodge Magnum SRT-8 V8-6.1L VIN 3
Assembly
2006 Dodge Magnum SRT-8 V8-6.1L VIN 3SECTION Assembly
ASSEMBLY
WARNING: To service any component of the SCCM, the entire assembly must be removed from the column. This must be done due to the clockspring passing through the assembly and into the self docking connector. Failure to remove the assembly could damage the pins of the clockspring and prevent the airbag system from operating properly.
1. Position the Steering Control Module (SCM) onto the multi-function switch.
2. Install the multi-function switch and SCM and tighten the three screws (1) from the bottom of the SCCM
3. Install the steering column telescoping lever (3).
4. Install the speed control switch (1).
5. If equipped with manual telescoping column, install the strut (1).
6. If equipped with electronic telescoping column, install the electric tilt lever and switch (3).
7. If equipped wit ESP, install the steering angle sensor and screw (3) located at the six o'clock position.
8. Install the clockspring and screws (1) leaving one out so it will not unwind.
9. Install the SCCM on the steering column, and tighten the one clockspring screw (1) that was left loose.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.