Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE2006MAGNUM SRT-8 V8-6.1L VIN 3REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD, ENGINE
2006 Dodge Magnum SRT-8 V8-6.1L VIN 3
Connecting Rod, Engine
2006 Dodge Magnum SRT-8 V8-6.1L VIN 3SECTION Connecting Rod, Engine
CONNECTING RODS
Piston Pin Bore Diameter 23.955 - 23.975 mm (0.9431 - 0.9438 inch)
Side Clearance 0.10 - 0.35 mm (0.003 - 0.0137 inch)
Connecting Rod Cap-Bolts 45 Nm plus 60° Turn (33 ft. lbs. plus 60° Turn)
Piston Pin Bore Diameter 23.955 - 23.975 mm (0.9431 - 0.9438 inch)
Side Clearance 0.10 - 0.35 mm (0.003 - 0.0137 inch)
Connecting Rod Cap-Bolts 45 Nm plus 60° Turn (33 ft. lbs. plus 60° Turn)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.