Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE1993COLT L4-1468CC 1.5L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCRANKSHAFT POSITION SENSORTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSSENSOR INSPECTION
1993 Dodge Colt L4-1468cc 1.5L SOHC
Sensor Inspection
1993 Dodge Colt L4-1468cc 1.5L SOHCSECTION Sensor Inspection
VOLTAGE TESTING PROCEDURE:
1. Connect an analog voltmeter between terminal 1 and 3 of the crank angle sensor connector.
Terminal 3: Crankshaft Position signal
Terminal 1: Sensor ground
2. Measure the output voltage of the terminals while cranking the engine.
Standard Approximate Values 1.8 - 2.5v (needle fluctuates)
3. When the voltage is abnormal, check the sensor power and ground circuits.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.