Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE1991SHADOW L4-135 2.2L SOHCREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW TRACKSERVICE AND REPAIR
1991 Dodge Shadow L4-135 2.2L SOHC
Window Track: Service and Repair
1991 Dodge Shadow L4-135 2.2L SOHCSECTION Service and Repair
REAR GLASS RUN CHANNEL
1. Remove trim panel, watershield, and door glass.
2. Work the upper glass run channel from the glass opening by inserting a small screwdriver into the door frame, behind the channel. Catch each clip with the screwdriver and carefully move it forward.
3. When the entire upper glass run channel has been separated from the glass opening, remove the lower fastener, and then the channel assembly.
4. Reverse this procedure to install using a piece of wood or plastic, measuring 3" x 2" x 1/4", as a tool for seating the channel in the door frame.
1. Remove trim panel, watershield, and door glass.
2. Work the upper glass run channel from the glass opening by inserting a small screwdriver into the door frame, behind the channel. Catch each clip with the screwdriver and carefully move it forward.
3. When the entire upper glass run channel has been separated from the glass opening, remove the lower fastener, and then the channel assembly.
4. Reverse this procedure to install using a piece of wood or plastic, measuring 3" x 2" x 1/4", as a tool for seating the channel in the door frame.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.