Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE1991SHADOW L4-135 2.2L SOHCREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW REGULATORSERVICE AND REPAIRPOWER WINDOW REGULATOR REPLACEMENT
1991 Dodge Shadow L4-135 2.2L SOHC
Power Window Regulator Replacement
1991 Dodge Shadow L4-135 2.2L SOHCSECTION Power Window Regulator Replacement
Front Door Window Regulator - Power:
FRONT DOOR
1. Remove trim panel and water shield and connect window switch to wire connector.
2. Raise glass to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.
3. Disconnect battery negative cable.
4. Remove bolts holding window regulator to inner door panel.
5. Slide roller from window lift channel. Rotate regulator to bring lift arm through access hole first.
6. Remove regulator assembly from door.
7. Reverse the preceding operation for installation.
REAR DOOR
1. Remove trim panel and water shield.
2. Position door glass 150 mm (6 in.) up into glass opening.
3. Remove bolts holding window regulator lift bracket to door glass.
4. Remove fasteners holding power window regulator to inner door panel.
5. By hand, pull glass upward to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.
6. Remove regulator assembly from door.
7. Reverse the preceding operation for installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.