Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE1991SHADOW L4-135 2.2L SOHCREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW REGULATORLOCATIONS
1991 Dodge Shadow L4-135 2.2L SOHC
Window Regulator: Locations
1991 Dodge Shadow L4-135 2.2L SOHCSECTION Locations
Two Door Model
The window regulator is a conventional sector gear design. The power window motor is attached to the window regulator. The window motor/regulator assembly is attached to the inner door panel of each front door.
Four Door Model
The front window regulator is a conventional sector gear design. The rear window regulator is a flex drive design. The power window motor is attached to the window regulator. The window motor/regulator assembly is attached to the inner door panel of each door.
Power Window Motor Location:
The window regulator is a conventional sector gear design. The power window motor is attached to the window regulator. The window motor/regulator assembly is attached to the inner door panel of each front door.
Four Door Model
Power Window Motor Location:
Power Window Components:
The front window regulator is a conventional sector gear design. The rear window regulator is a flex drive design. The power window motor is attached to the window regulator. The window motor/regulator assembly is attached to the inner door panel of each door.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.