Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE1987SHADOW L4-135 2.2L SOHC TURBOREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIR
1987 Dodge Shadow L4-135 2.2L SOHC Turbo
Power Window Switch: Service and Repair
1987 Dodge Shadow L4-135 2.2L SOHC TurboSECTION Service and Repair
Removal
To remove the power window switches, carefully pry the power window switch bezel from the center console. Use a small flat bladed screwdriver to release the wiring harness lock tabs and carefully separate the wiring harness from the back of the switch. Remove the screws that attach the power window switch to the bezel.
Installation
Secure the power window switch to the bezel with the original screws. Press the wiring harness onto the back of the power window switch, making sure that the lock tabs completely engage. Press the bezel onto the center console, making sure the clips firmly engage.
To remove the power window switches, carefully pry the power window switch bezel from the center console. Use a small flat bladed screwdriver to release the wiring harness lock tabs and carefully separate the wiring harness from the back of the switch. Remove the screws that attach the power window switch to the bezel.
Installation
Secure the power window switch to the bezel with the original screws. Press the wiring harness onto the back of the power window switch, making sure that the lock tabs completely engage. Press the bezel onto the center console, making sure the clips firmly engage.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.